The bathroom is the area we pay more attention to when decorating. The waterproof and ventilation work in the bathroom are very important. Generally, partitions are added in the bathroom to achieve the separation of dry and wet. So what details should be paid attention to in the installation of toilet partitions? Jinan toilet partition manufacturer gave 6 details.
1. After paving floor tiles and wall tiles, make toilet partition
When decorating the toilet, the floor tiles and wall tiles shall be paved first, and then the toilet partition wall shall be customized according to the actual required size. Note that before laying floor tiles, drainage pipes and floor drains must be installed. At the same time, possible errors on the upper and lower walls must be considered. The glass door can be installed and used only when it is customized according to the actual size.
2. Considering the water retaining property of door frame and threshold
Consider whether the glass partition of the toilet has a door frame to block water. If there is no special threshold stone, the threshold stone should be 1.5cm - 2cm higher than the ground in general, otherwise the shower water will flow out from under the door, which will not achieve the purpose of dry and wet partition and will cause inconvenience.
It is recommended not to use the glide slope when there is enough space, because it is difficult to remove water and dust in the glide slope, and it will smell after a long time. If the space is insufficient, you can choose the sliding door of the slide to save space, but you must clean up and clean the dead corner in time to avoid the above phenomenon.
3. A hand lever should be installed at the side of the bathtub
The bathtub in the bathroom is a place where the whole family members need to take a bath. In addition, there are water, shower gel and other dangerous factors that may cause slipping in the bathroom. Therefore, in order to ensure safety, the bathtub should be equipped with a handle as far as possible, especially if there are elderly people and children at home.
4. The electrical plug should be far away from the bathtub
The bathtub is a container for storing water, and the electrical plug should not appear around as much as possible. Generally, many people will blow dry in the bathroom after washing their hair in the bathroom. If someone is in the bathtub at this time, the activated electrical appliance will fall into the water, which will be fatal. Therefore, the electrical plug should be installed as far away from the bathtub as possible, just in case.
5. Damp proof measures shall be taken for switching power supply
The toilet should be the home's water base, so in order to ensure safety, we should plan to use pull wire switches when decorating the toilet, and try to add moisture-proof covers for its power sockets and other energized equipment.
6. Glass doors shall be organic or tempered glass
The glass door of the shower shall be plexiglass or tempered glass to avoid personal injury. If the glass is colorless, try to paste the pattern at the appropriate sight level to avoid damaging the glass.
The above are the details of the bathroom partition installation that we need to pay attention to. I hope it will be helpful to you when installing the bathroom partition. You can follow our website http://www.jnndjc.com
Ask for more!