如今济南卫生间隔断想必已经很普及了，在一些公共场所，这种隔断给大家的糊口带来诸多便利。卫生间的设计基本上以利便、、易于清洗及美观患上体为主。对于于安装技术人员来说，怎么快速掌握卫生间隔断安装技巧呢？
Nowadays, Jinan toilet partition must have been very popular. In some public places, this partition brings a lot of convenience to everyone's life. The design of the toilet is mainly convenient, safe, easy to clean and beautiful. For installation technicians, how to quickly grasp the installation skills of toilet partition?
1、墙壁固定片
1. Wall fixing piece
墙壁上画出固定片的中心线，用电钻在线上三处钻孔后预埋塑胶塞套于孔内，再将固定片用膨胀螺丝固定于墙面上。
Draw the center line of the fixing piece on the wall, drill three holes on the line with an electric drill, embed plastic plugs in the holes, and then fix the fixing piece on the wall with expansion screws.
2、调剂脚座
2. Adjusting foot base
地板画出调剂脚坐位置中心线，将调剂脚座，固定在离隔间板前缘一五0地板上。
Draw the center line of the adjustment foot sitting position on the floor, and fix the adjustment foot seat on the floor 150 away from the front edge of the compartment board.
3、隔板间
3. Diaphragm room
将隔间板立靠在墙壁固定片及调剂脚座上，调高此板离地，正常高度一四五，肯定水平后，用螺丝将隔间板固定在墙壁固定片及调剂脚座上。
Stand the partition board against the wall fixing piece and the adjusting foot base, and raise the board to the ground, with the normal height of 145. After confirming the level, fix the partition board on the wall fixing piece and the adjusting foot base with screws.
4、立柱
4. Column
中间立柱－－用螺丝将拉杆固定片，固定于立柱中间顶端上图四，以L型固定片片，将立柱与隔间板固定结合1体墙边立柱－－在墙面上画出与地面垂直之直线，以电钻在线上三外钻孔，预埋塑胶塞套于孔内，肯定与地垂直后，用螺丝以L型固定片，将墙边立柱固定在离地一四五高处墙壁上。
Middle column - fix the pull rod fixing piece on the top of the middle of the column with screws (Figure 4 above). Fix the column and the partition plate with L-shaped fixing piece and combine them with the wall column of body 1 - draw a straight line perpendicular to the ground on the wall surface, drill three holes on the line with an electric drill, embed a plastic plug in the hole, and fix the wall column with L-shaped fixing piece with screws on the wall at a height of 145 above the ground.

终端立柱－－固定上缘拉杆固定片及L型边接片于终端立柱上，再以螺丝将此板固定于隔间板上。
Terminal column - fix the upper edge pull rod fixing piece and L-shaped edge connecting piece on the terminal column, and then fix the plate on the compartment plate with screws.
5、拉杆
5. Pull rod
依隔间实际长度裁切固定，直线拉杆平接时，管内须加装圆形相接套及紧急连接弹簧片以肯定接头平整、牢靠，其相接处应在上绷固定片内，以增添美观。对于于隔间九0度转角拉杆，采取铝合金射出成型之九0度转角接头，连接转角两端之拉杆。
Cut and fix according to the actual length of the compartment. When the straight-line pull rod is connected horizontally, a circular connecting sleeve and an emergency connecting spring piece shall be installed in the pipe to ensure that the joint is flat and reliable. The joint shall be stretched in the upper fixing piece to add beauty. For the 90 degree angle tie rod in the compartment, the 90 degree angle joint formed by aluminum alloy injection is used to connect the tie rods at both ends of the corner.
以凸圆形墙壁固定套，用螺丝将终端拉杆固定在墙面上。使用螺丝将拉杆于立柱上缘固定片连接固定1起。
The terminal pull rod is fixed on the wall with a convex circular wall fixing sleeve and screws. Use screws to connect and fix the pull rod to the fixing piece on the upper edge of the column.
6、门扇
6. Door leaf
铰链座上、下固定于立柱上，铰链片固定于门扇上、下两处，将自动归位尼龙座放置铰链座内，能使门扇依咱们所需之角度自动开、关自若。将唆使锁固定立柱上、无人使历时，唆使锁会显示绿色，关锁时会显示红色，当突发紧迫状态时，可由外面打开唆使锁，以利紧迫之需要。
The upper and lower parts of the safety hinge seat are fixed on the column, and the hinge pieces are fixed on the upper and lower parts of the door leaf. The automatic return nylon seat is placed in the hinge seat, so that the door leaf can be opened and closed automatically according to the angle we need. Fix the safety instigate lock on the column and leave it unattended for a long time. The instigate lock will display green and the lock will display red when it is closed. In case of emergency, the safety instigate lock can be opened from the outside to meet the urgent needs of safety.
相信以上的内容大家都会有了多多少少的了解，但愿这篇文章可以帮助到你们，更多相关问题可关注我们网站http://www.jnndjc.com咨询了解。
I believe that all of you will have more or less understanding of the above contents. I hope this article can help you. For more related questions, please follow our website http://www.jnndjc.com Consultation and understanding.