Next step of toilet spacing device: drawing device fixing plate
Find a suitable orientation on the wall and draw the middle * line of the fixing plate. Generally, six corner codes need to be installed on the fixing plate, and the corresponding devices are installed on the plate as needed. Then, holes are punched on the orientation corresponding to the center line of the wall, and the plastic race sleeve is put into the hole. Next, the fixing plate is fixed on the wall with expansion screws. Finished partition of Jiangxi toilet
Step 2 of toilet spacing device: adjust the base of the device
According to the pre-designed construction drawing, find the orientation of the base on the toilet floor and draw the outgoing line, and then fix the base (the orientation of the base is about 3cm away from the edge of the partition)
Three steps of toilet partition device: install partition plate
The first two steps are to set off the cubicle plate of the device. The function of the fixed plate and the base is to fix the cubicle plate. Put the cubicle plate on the adjusting base, and then adjust the concave convex of the base to make the cubicle plate close to the fixed plate on the wall, and then fine tune the concave convex of the base to make the cubicle plate have a certain distance from the ground, about 7cm-10cm. After ensuring that the height of the bottom reaches, confirm the level with a level ruler, and everything is adjusted, Fix the compartment plate on the fixing plate and adjusting base with screws.
Four steps of toilet spacing device: pull rod
Cut and fix according to the actual length of the compartment. When the straight-line pull rod is flat connected, a circular connecting sleeve and an urgent connecting spring sheet must be installed in the pipe to confirm that the joint is flat and firm, and the joint shall be in the upper tension fixing sheet to increase the appearance. For the 90 degree corner pull rod of the compartment, the 90 degree corner joint formed by aluminum alloy injection is selected to connect the pull rods at both ends of the corner. Fix the sleeve on the convex circular wall, and fix the terminal pull rod on the wall with screws. Use screws to connect and fix the pull rod with the fixing piece on the upper edge of the column.
Five steps of toilet spacing device: device column
Fix the pull rod fixing piece on the top of the column with screws, and fix the column and the compartment board with L-shaped fixing piece. The wall column - draw a straight line perpendicular to the ground on the wall, drill 3 holes on the line with an electric drill, and embed the plastic plug in the hole. After confirming that it is perpendicular to the ground, fix the wall column on the wall 145 above the ground with L-shaped fixing piece with screws. Terminal column - fix the upper edge pull rod fixing piece and L-shaped edge connecting piece on the terminal column, and then fix the plate on the compartment plate with screws
Six steps of toilet spacing device: install door leaf
Fix the hinges on the column, usually 2-3, and then install the corresponding number of hinges on the corresponding orientation device on the door leaf, gently lift the door leaf, place the active homing nylon seat in the hinge seat, adjust the orientation, open and close the door to check that the door leaf can be opened and closed naturally, and check the adjustment until the partition of Zhejiang public toilet is stopped satisfactorily
The wonderful content of this article is provided by the toilet partition. There are many wonderful content on this website. You can click to enter more content: http://www.jnndjc.com We have special customer service to answer your questions