Step 1: draw a line to install the fixing plate
In order to find a suitable position on the wall to draw the center line of the fixed plate, usually install six corner codes on the fixed plate and install them on the plate as required. Then, drill holes in the corresponding positions on the wall, put the plastic sleeve into the holes, and fix the fixing plate on the wall with the expansion screws.
Public toilet partition
Step 2: install the adjusting base
According to the pre-designed construction drawing, find the base position on the floor of the toilet, draw the center line, and then fix the base (the base position is about 3cm away from the edge of the partition)
Step 3: install the compartment board
The first two steps are to pave the way for the installation of partitions. The function of the fixing plate and the base is to fix the diaphragm. The clapboard is placed on the adjusting base, then the height of the base is adjusted, so that the clapboard is near the fixed plate of the wall, and the height of the base is fine-tuning, so that the baffle plate has a certain distance from the ground, about 7 centimeters -10 cm. After the height of the base is determined to be 1-1, the level shall be determined with a level ruler. After everything is adjusted, the partition plate shall be fixed on the fixing plate and the base shall be adjusted with screws.
Public step 4: install the pull rod
Cut and fix according to the actual length of the compartment. When connecting the straight rod horizontally, the pipe needs to be equipped with a circular connecting sleeve and an emergency connecting spring plate to ensure that the joint is flat and firm. Connections shall be made at the upper tension fixings to increase aesthetics. For the 90 degree angle rod in the carriage, the 90 degree angle joint of aluminum alloy injection molding is used to connect the rod at both ends of the angle. The end tie rod is fixed on the wall with convex and round wall fixing sleeve and screw. Connect the pull rod with screws and fix it on the upper edge fastener of the column.
Step 5: install the column
The pull rod fixing part is fixed at the top of the middle of the column with screws, and the column and the partition are fixed and combined into a wall side column - draw a straight line perpendicular to the ground on the wall surface, drill holes on the three outer sides of the straight line with electric drill, and the holes are covered with embedded plastic plugs. After confirming that they are perpendicular to the ground, fix the wall side column on the wall 145 away from the ground with L-shaped fixing parts with screws. Terminal post - secure the upper edge tie rod fixings and L-edge connections to the terminal post and screw the board to the bulkhead
Public toilet partition
Step 6: install the door leaf
Fix the hinge on the column, usually 2-3, then install the corresponding number of hinges on the door leaf at the corresponding position, lift the door leaf gently, place the automatic return nylon seat in the hinge seat, adjust the position, open and close the door, check whether the door leaf can be opened and closed freely, check and adjust until it is satisfied.
With the summary above the toilet partition in Jinan, I hope it can help our customers. If you don't understand or ask for help, please click our website: http://www.jnndjc.com Or call for consultation, we will do our best to solve it for you